Other Attachments

Riddle Buckets, Trapezoidal "V" Type Trenching buckets, Underpinning Bucket, Grave Digging Bucket, Deep Digging Bucket,

Land & Stone Rakes, Adaptor Plates for Hammers And Other Attachments, Interlocking Tine Grabs, Spring Type Manual Quick Hitch,

	Riddle Buckets For Any Size Excavator
	Type 1 : Bars across the bucket mainly used for riddling stones from soil
	Type 2 : Bars Around the bucket, Mainly used by landscapers for clearing banks etc.
	Type 3 : Grid Type Riddle Bucket, Used in Quarries and for efficeint sizing of products Click for Riddle Bucket Flyer
	Trapezoidal "V" Type Trenching buckets Made To Suit Requirements
	A useful addition for digging narow bottomed trenches for pipelaying and as a drainage digging bucket Made to suit your individual requirements
	Special Underpinning Bucket
	A specially designed bucket for digging out for the underpinning of buildings
	Grave Digging Bucket
	Special purpose bucket for achieving a flat bottomed grave with ease
	Deep Digging Bucket
	A digging solution when dipper with is wider than desired width of trench Made to suit digging depth required Click for Deep Dig Bucket
	Land & Stone Rakes
	Used for clearing brush and raking stones out of soil plus a multitude of other purposes Length of tines and gap width made to suit requirements Click for Land Rake Flyer
	Adaptor Plates for Hammers And Other Attachments
	We manufacture hammer tops for all the manufacturers of breakers and provide adaptor plates for any attachment neede to be fitted to an excavator
Grab Closed Grab Gripping Load Grab Fully Open	Interlocking Tine Grabs
Grab Closed Grab Gripping Load Grab Fully Open	A very useful grab for site clearrance and loading of awkward materials, Manufactured with flame cut tines to your specifications and provided with an adjustable relay bar which is welded to the dipper arm The grab is powered by the bucket ram and is easily mounted Hardox 400 tines supplied as an option Click for Mechanical Grapple Flyer Click for Box Tine Grapple Flyer
	Ripper Tooth
	Dimensions & specifications for 1.5 tonne to 13 tonne excavators can be found on the diagram below. We also manufacture ripper teeth for micro excavators and excavators up to 30 tonnes. Please call our Sales Team for further information and prices on 01639 630587. Click for Ripper Tooth Flyer
	Tilting Ditching Bucket
	All tilting ditchers are twin ram, and can tilt 45 degrees left and right. Pilot operated check valves are fitted to every unit to prevent loss of control if a hose breaks. These valves also stop the accumulator effect when the excavator is lifted up on one end of the tilting ditcher. Without the valves the tilt angle would not hold, and the bucket would move through a few degrees. The valves do not need adjusting or routine maintenance; they must always remain in the circuit. Variable orifice valves are also fitted to control the speed of movement. These valves are important to prevent damage to the system or bucket if the bucket tilts too quickly. Full instructions regarding set up are supplied with every bucket Manufactured for all makes and models of excavator from 2 to 20 tonnes Twin ram Click for Tilting Ditcher Flyer
	Clay Buckets

	Turf Lifter